Use of electric lock

Use of electric locks
Lock status: whether it is locked is one of the important parameters of electromagnetic locks. For electric bolt locks without locks, the normal current is the same as the current when the bolt is in action, the power consumption is large, the lock body temperature is high, and if the heat dissipation effect is poor during installation, it may shorten the service life of the lock body; while the normal current of electric bolt locks with locks is less than half of the action current, the power consumption is small, the lock body temperature is low, and the service life is long. Other lock conditions can be used as the basis for the controller to judge the door opening timeout alarm.
Adjustable delay: The so-called delay refers to the length of time from the lock opening, the person entering and closing the door, and the electric bolt lock is locked again. If it exceeds this time range, the door opening timeout alarm signal will be generated.
Locking beads: The locating beads are sliding beads that help locate the door body when the door returns. Generally, glass doors use adjustable floor springs to control the stability and accuracy of the door body return, while wooden doors use door closers to control the door body return, so the role of the locating beads is not great.
At the same time, the friction noise generated by the positioning beads is also large, which affects the office environment of the office area.

Electric lock device accessories
In most cases, it is necessary to use some accessories for electric lock devices. When selecting electric locks, users should clearly describe the specific door body

conditions and installation requirements. The following is a detailed introduction to several accessories that may be used for electric lock devices.

Lower door clamps matched with electric locks: When the glass door body has no frame, it is necessary to use lower door clamps. The lower door clamps are generally made of aluminum alloy and are directly clamped on the door glass.

Upper and lower door clamps matched with electric locks: When the glass door body is frameless glass on the top and bottom, it is necessary to use upper and lower door clamps. Because the upper door clamp requires the electric lock body to be wrapped and fixed on the glass, the upper door clamp is required to be of very good quality and large in size,

generally stainless steel materials are used. At the same time, the lower door clamp must be matched with the upper door clamp, which is different from the lower door clamp selected separately. The cost of upper and lower door clamps is relatively expensive.

L-shaped bracket for electromagnetic lock: When the iron door opens inward, it is often necessary to select an L-shaped bracket. This bracket is mostly made of aluminum alloy.
U-shaped bracket for electromagnetic lock: When the glass door body has no frame, it is necessary to use a U-shaped bracket. This bracket is mostly made of aluminum alloy.
Anode lock body for electric control lock: This lock body is generally a mechanical anti-theft lock, and the lock tongue is not required to be a square tongue.