How to connect the two wires of the magnetic lock to the access control power supply

Magnetic locks are usually used for door lock control in access control systems. Magnetic locks usually work by connecting to the access control power supply, which is a device used to provide the power required by the magnetic lock. Connecting the two wires of the magnetic lock to the access control power supply is an important step in the access control system. Connecting the wrong wires may cause the system to not work properly or cause safety hazards. Next, I will introduce in detail how to connect the two wires of the magnetic lock to the access control power supply.

First, we need to confirm the colors of the two wires of the magnetic lock and the access control power supply. Usually the two wires of the magnetic lock are red and black, while the two wires of the access control power supply are blue and white. Make sure the colors of the wires correspond correctly to prevent wrong wiring.

Next, connect the red wire of the magnetic lock to the blue wire of the access control power supply, and connect the black wire of the magnetic lock to the white wire of the access control power supply. In this way, the same color wires are connected to complete the connection of the two wires of the magnetic lock to the access control power supply.

After the wiring is completed, you need to wrap the interface with insulating tape or other insulating materials to prevent short circuit or leakage. In addition, before wiring, you need to make sure that the access control power supply is working properly, and before turning on the power, make sure that the access control system is in the off state to avoid current shock.

Finally, after completing the wiring, you can test the access control system to verify whether the switch status of the magnetic lock is normal. If the magnetic lock works normally, it means that the wiring operation is correct and you can start using the access control system normally.

In general, connecting the two wires of the magnetic lock to the access control power supply is a key step in the installation of the access control system, and careful operation is required to ensure the normal operation and safety of the system. I hope the above introduction can help you correctly connect the magnetic lock to the access control power supply.